Page 1799 of 3265
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 9:44 am
by Strange Tales
Pretty much just for good rocking sounds. It has basically completely replaced my Walrus Mayflower pedal as the main OD I use, at least for bass. I don't think I've actually used it with guitar yet.
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 1:38 pm
by Sparrow
Sparrow wrote:Incoming!
picked it up from the mailbox.
it's at home
with bonus velcro and missing screw! ( i already replaced it )
can't wait to plug it in later today!!
i see that there's a trim pot inside. anyone fiddle with theirs?
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 2:16 pm
by kbit
Check the ss/bs sub forum for info, I think its a bias control and is usually set to where it sounded best to Bri.
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 2:19 pm
by D.o.S.
Strange Tales wrote:Pretty much just for good rocking sounds. It has basically completely replaced my Walrus Mayflower pedal as the main OD I use, at least for bass. I don't think I've actually used it with guitar yet.
Yeah it's like the black sheep of the Skychord family in that regard.
I want to say its related to the Hao Rust Driver, but that could just be word association in my brain linking the two.
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 2:20 pm
by UglyCasanova
That TAFM is so sick!
In: MASF Rapito
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 2:49 pm
by kbit
D.o.S. wrote:Strange Tales wrote:Pretty much just for good rocking sounds. It has basically completely replaced my Walrus Mayflower pedal as the main OD I use, at least for bass. I don't think I've actually used it with guitar yet.
Yeah it's like the black sheep of the Skychord family in that regard.
I want to say its related to the Hao Rust Driver, but that could just be word association in my brain linking the two.
I kinda think they might use part of the circuit in their sleepdrones. But that's purely speculation.
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 3:41 pm
by Uncle Grandfather
NNNNNNNNNNNNNNNNNNNNn
Mountainking Electronics Behemoth II
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 5:50 pm
by ApeLincoln
Might have worked out a trade, my big muff Pi with tone wicker and some blank cassettes for a boss RPS-10. If it falls through I'm gonna think hard about snagging one off evilbay
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 7:57 pm
by Sparrow
Sparrow wrote:
Clean Volume and Fuzz Volume ftw!
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 8:01 pm
by sylnau
Flangerine
From FuzzHugger(fx)
Re: What is in the post? The thread of and for GAS!
Posted: Fri Feb 13, 2015 9:01 pm
by fever606
Sparrow wrote:Clean Volume and Fuzz Volume ftw!
So true! I really dig the clean volume maxxxed and the fuzz volume letting just a hint of grunt through... then hit it with your favourite OD with the gain dimed (DOD 250 was aces for this, currently deafening small woodland creatures with the Big Spider out front). So happy to have a TAFM again...
Re: What is in the post? The thread of and for GAS!
Posted: Sat Feb 14, 2015 6:26 am
by goroth
sylnau wrote:Flangerine
From FuzzHugger(fx)
Hnnnnng!
Re: What is in the post? The thread of and for GAS!
Posted: Sat Feb 14, 2015 3:26 pm
by backwardsvoyager
Boss MZ-2 digital metalizer incoming
i kept forgetting how much i wanted one of these
Re: What is in the post? The thread of and for GAS!
Posted: Sat Feb 14, 2015 3:30 pm
by John
backwardsvoyager wrote:Boss MZ-2 digital metalizer incoming
i kept forgetting how much i wanted one of these
Oh you bitch, did you snag the one in B/S/T? Fuuuuuu
Re: What is in the post? The thread of and for GAS!
Posted: Sat Feb 14, 2015 3:36 pm
by kbit
Shopping for knobs is hard
But, incoming: knobs for my drone synth!
26 of them
