Page 2 of 11

Re: Okta 3? [we are go!]

Posted: Sat Jul 10, 2021 5:42 pm
by Heraclitus Akimbo
We are currently ten participants! More is still very cool, in case you are are quietly skulking around the edges of this thread. :group:

Folks listed above, let me know if you have any questions/comments/complaints! :poke:

Re: Okta 3? [we are go!]

Posted: Sat Jul 10, 2021 7:42 pm
by dubkitty
the questions will probably come down the road, stuff like is this long enough/too long, too simple/complicated, recorded well/not well enough, and the like. i have to try and figure out some way to get sounds down without a computer to record on other than the work-from-home laptop that belongs to my employer who frowns upon downloading non-approved software, or the ability to connect a decent mic to my iPhone which has no 3.5 mm jack. i just may wind up with no-fi recordings, which might not be entirely bad because they'd be a fairly blank canvas.

Re: Okta 3? [we are go!]

Posted: Sat Jul 10, 2021 7:51 pm
by dubkitty
Will be in a cabin for much of august without any guitars, so hopefully I can get something in within the next month.
non-guitar found sounds could be extremely useful...think of Eno's On Land. take microphones outside and record the birds, the frogs, the rain, and the wind in the trees. also if there's a body of water or a river/stream water sounds would be great.

Re: Okta 3? [we are go!]

Posted: Sun Jul 11, 2021 12:01 pm
by manymanyhaha
Heraclitus Akimbo wrote: All stems/source tracks should be at 24 bit 48k resolution / under ten minutes.
Experience has taught us that for the stems, shorter is generally better.
Experience has also taught us that for the stems, basic is better. Fewer effects, less "produced", less elaborate, less structured — after all, someone else is going to add their own effects/structure when they build their track in phase 2.
And suitable for an "ambient" compilation.

Few constraints makes the imagination spin!

Apologies, I only heard the results of the first two, not the source tracks. Are we to contribute one source track?

Re: Okta 3? [we are go!]

Posted: Sun Jul 11, 2021 12:58 pm
by Heraclitus Akimbo
manymanyhaha wrote: Apologies, I only heard the results of the first two, not the source tracks. Are we to contribute one source track?
The previous rule of thumb I gave was 1 to n source tracks, where n is the number of participants. So, no hard limits but maybe not more than 10 things?

From the way I work with the source pieces, I'd say more short things give better pickings than, say one long one. On the other hand, I've used mid-length ones as the sort of pad or bed for tracks I've assembled.

Re: Okta 3? [we are go!]

Posted: Sun Jul 11, 2021 8:02 pm
by manymanyhaha
Awesome, makes total sense, thank you!

Re: Okta 3? [we are go!]

Posted: Sun Jul 11, 2021 11:01 pm
by the_bright_undead
Heraclitus Akimbo wrote: Folks listed above, let me know if you have any questions/comments/complaints! :poke:
Will 16 bit / 44K be alright for this? I think that for the immediate future (the next couple of months), that's gonna be my upper limit in terms of file fidelity/resolution....if that's gonna mess it up for everyone else, I should duck out and wait for the next round.

Re: Okta 3? [we are go!]

Posted: Sun Jul 11, 2021 11:03 pm
by the_bright_undead
dubkitty wrote:
Will be in a cabin for much of august without any guitars, so hopefully I can get something in within the next month.
non-guitar found sounds could be extremely useful...think of Eno's On Land. take microphones outside and record the birds, the frogs, the rain, and the wind in the trees. also if there's a body of water or a river/stream water sounds would be great.
Makes me wish I still had my old Zoom field recorder, I lost it a long time ago. But I do still have a lot of raw material on a hard drive somewhere, which was originally meant for use in some ambient sound experiments.....I'll see if I can find the old folders......

I could also just get a Volca and bring it out to the woods :)

Re: Okta 3? [we are go!]

Posted: Sun Jul 11, 2021 11:05 pm
by Heraclitus Akimbo
the_bright_undead wrote: Will 16 bit / 44K be alright for this? I think that for the immediate future (the next couple of months), that's gonna be my upper limit in terms of file fidelity/resolution....if that's gonna mess it up for everyone else, I should duck out and wait for the next round.
Nah, it'll be fine! I'm no Fidelity Freak, won't cause a problem for folks to upconvert.

Re: Okta 3? [we are go!]

Posted: Sun Jul 11, 2021 11:12 pm
by the_bright_undead
Heraclitus Akimbo wrote: Nah, it'll be fine! I'm no Fidelity Freak, won't cause a problem for folks to upconvert.
:joy:

Re: Okta 3? [we are go!]

Posted: Mon Jul 12, 2021 10:03 am
by Dowi
low fi is our hi fi

:zen:

Re: Okta 3? [we are go!]

Posted: Mon Jul 12, 2021 12:33 pm
by dubkitty
LO FI IS THE NEW HI FI

Re: Okta 3? [we are go!]

Posted: Mon Jul 19, 2021 4:26 pm
by Heraclitus Akimbo
Think I got my first Okta sounds down... was noodling away on the lap steel with a l'il tube drive pedal that showed up the other day. Ended up with something that might even be a keeper for something else I'm working on, but the tone trials on the way there should provide something appropriate.

And then put away the lap steel today to make a different setup, so fooling around with that over the course of the week might lead to some more sounds.

Re: Okta 3? [we are go!]

Posted: Tue Jul 20, 2021 8:45 pm
by MrNovember
Damn, I'm sad I'm missing round three; I guess I haven't been lurking on here enough lately! Oh well, I honestly don't think I would have had the time to commit to this right now anyways, but subscribing to listen to the final results!

Re: Okta 3? [we are go!]

Posted: Wed Jul 21, 2021 5:42 pm
by dubkitty
good thing the pieces aren't due till the 15th...i burned my left-hand fingertips trying to fix a pair of nylon-strapped Teva sandals and they peeled for over a week before revealing blisters on the 1 and 3 fingers. they hurt like hell and aren't going to be guitar-friendly for at least another week. i guess i can do faux lap steel with a guitar laying flat on my lap if all else fails.